Bullet Tools 213-SID Use and Care Manual download pdf (Page 6)

Laminate Flooring

Engineered Wood

Commercial Vinyl

Luxury Vinyl Tile

Parquet

Permastone

™

PVC Tile

Rubber Cove Base

Rubber Tile

Soft Plastic

Siding, Fiber Cement Board

Siding, Pressboard Lap

Siding, Vinyl

Siding, Wood

Trim, OSB

Trim, Fiber Cement

Trim, Vinyl

Shingles, Tar or Wood

ACCESSORIES

All Angle Fence

Item #701AF

Set any angle from 0

to 90

Shear Stand

Item #709

Allows you to cut with the

shear oﬀ the ground�

Honing the Blade

MAINTENANCE

Push the handle down until blade is 1/4” (6mm) open.

Lay the hone stone against the at face of the blade

(side toward the table). Slide from end to end 2 or 3 times.

This removes the small burr formed when cutting hard

products.

Hone every 100 cuts

After every 100 cuts, it is recommended that you lubricate

the wear points of the pins and the bearings as shown.

Use a light oil (i.e. 10W motor oil). This will prevent the

machine from wearing out prematurely. Apply grease

(wheel bearing grease) frequently to the bearings where

indicated�

Your EZ Shear cuts a wide variety of products.

Please refer to this cut guide for

recommended products and thicknesses.

Please note: Approved materials may vary in density

and hardness. If extreme pressure is required to cut

a product, it may result in damage to your machine.

Please contact Bullet Tools before proceeding. Warranty

is void if an unapproved product damages the machine.

SST CUT GUIDE

Maximum Thickness = 25mm or 1”

Material

Do NOT Use on

High Pressure Laminate

or Solid Wood!

Replacement Blade for 213SID is part #213B

Greasing / Lubricating

Oil

Grease

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Bullet Tools 213-SID Use and Care Manual Page 6

Comments to this Manuals