USER GUIDERead Before Use!Do not use on High Pressure Laminate or Solid Woodwww.BulletTools.com • 208-772-0175 PRT-INS-0220 RevB.05.13 ©2013 Bullet
21 ����� READ AND UNDERSTAND THIS INSTRUCTION MANUAL BEFORE OPERATING THE EZ SHEAR™� 2 �����If you are not thoroughly familiar with the operation of t
3SST220 SET UpSST226 SET UpYou will need #2 & #3 Phillips head screwdriversand a 1/2” (13mm) socket or wrench. You will need #2 & #3 Phillips
44. TO ATTACH HANDLE:For 220:Insert Item F screws and tighten with 1/2” wrench.For 226:Insert Item F screws through back stroke stop and tighten with
52While gently pushing handle down, pull Safety Lock Pin out, then lift handle.135. PLACE THE FENCEFor 220:Your EZ Shear is equipped with an aluminum
6The 226 Shear has two Leverage ModesMode 1: Use the long-stroke cams (black lobes) only for lightweight products thicker than 1/2 inch.Mode 2: For al
7ACCESSORIESAll Angle Fence Item #701AF Set any angle from 0º to 90ºShear Stand Item #709Allows you to cut with the shear off the ground� Honin
www.BulletTools.com • 1-208-772-01750 500 1000 1500Janka Hardness ScaleNote: Due to extreme variations in wood density, your shear may or may not c
Comments to this Manuals